Prints – It's Filamental

Heavy Duty Hook for Cubicle

Austin — Tue, 25 Jul 2023 01:24:45 +0000

3D printed part: Printed with PLA plastic.
Strong: Printed with thick walls and high infill to make the hook strong enough to hold a coat.
Versatile: Holds coats, headphones, hats, and more!

Pop Filter Mount for Audio-Technica AT2020 (Printed)

Austin — Tue, 25 Jul 2023 00:58:32 +0000

This is a mount for the Audio-Technica AT2020 to add a pop filter on the stand mount. This should work for the AT2020USB too because it appears to come with the same stand mount.

All you need to do is take the screws off of your pop filter then pry the two halves apart just enough to slide the printed part in. The bottom of the pop filter should touch the base of the mount. Once you snap it back together and screw it together, it should feel solid.

I have found that this is much easier to use than the goose neck that comes with the pop filter. They always require a lot of maneuvering to get them in the right place plus they’re heavy. This is a lot lighter. My mic scissor arm actually stays where I put it now instead of lowering slowly due to the weight of the pop filter.

Audio-Technica AT2020
Pop Filter

15mm Rod Screw (Printed) [4/8 Pack]

Austin — Sat, 07 May 2022 23:03:19 +0000

This is a screw to cap the end of 15mm rods for shoulder rigs and rod mounted rigs. A 4-pack is great for adding caps to a single rig. If you have multiple rigs, get an 8-pack and you’re covered for two rigs.

Currently available in two colors, black and gray. Printed to order. Orders process in as little as two days!