Pop Filter Mount for Audio-Technica AT2020 – STL ONLY

This is a mount for the Audio-Technica AT2020 to add a pop filter on the stand mount. This should work for the AT2020USB too because it appears to come with the same stand mount.

All you need to do is take the screws off of your pop filter then pry the two halves apart just enough to slide the printed part in. The bottom of the pop filter should touch the base of the mount. Once you snap it back together and screw it together, it should feel solid.

I have found that this is much easier to use than the goose neck that comes with the pop filter. They always require a lot of maneuvering to get them in the right place plus they’re heavy. This is a lot lighter. My mic scissor arm actually stays where I put it now instead of lowering slowly due to the weight of the pop filter.

Audio-Technica AT2020
Pop Filter

5 perimeters
5 top layers
5 bottom layers
10% infill